SnapLok drill and rod adaptors

SnapLok adaptors connect the bottom sweep rod to the drill or drill driver, join the large and small SnapLok rods or fit a threaded manual brush onto the rods. Choose by the fitting on the rod:

8 and 10 mm rods (small fitting): DA600, or the DQ600 quick release.
12 to 22 mm rods (large fitting): DA800, or the DQ800 quick release.
Liner breakers and heavy heads: DA800H with a hex shank that does not slip in the drill chuck.
Combining large and small fittings: step adaptor ADPT305, for example to run a Propeller Brush on a 12 mm rod.
Manual brushes on 12 to 22 mm rods: ADPT705 (Universal), ADPT805 (1/2" Whitworth), ADPT108 (M8), ADPT908 and ADPT905 (M10).
A fixed handle for tar and nests: Power Grip Handle PGH6 with starter rod SNR159 and quick disconnect adaptor DQADPTL.

The drill adaptors are stainless steel. A quick release adaptor (DQ) stays on the rod while it turns at an angle under pressure and comes off when the rod is straightened and the drill is pulled back. Ventichim in Zandhoven distributes SnapLok in Belgium.

SnapLok drill adaptors, rod adaptors and Power Grip Handle

SnapLok DA-600 stainless steel drill adaptor with small fitting for 8 and 10 mm rods

SnapLok drill adaptor stainless steel for 8 to 22 mm rods

5 variants

SnapLok ADPT-305 step adaptor from large female to small male fitting

SnapLok rod adaptor to small fitting or threaded brush

6 variants

SnapLok Power Grip Handle PGH-6 in stainless steel with foam grip and SnapLok fitting at each end

SnapLok Power Grip Handle 150 mm for 12 to 22 mm rods

3 variants